THIS PAGE IS DISPLAYING 13 PICTURES AND TEXT
THERE IS 1 PAGE IN THIS SECTION
• PLEASE SCROLL DOWN •
THE PROBLEM ON THE SOUTH SIDE IS THE BANKING
ON THE NORTH SIDE, AS THIS PICTURE SHOWS
LIN AND I USED THE 20 FOOT RAMPS TO
SLIDE THE TIN UP ON TO THE ROOF
NEED ANOTHER WAY ON THIS SIDE
THIS HOME MADE HINGE USING TWO GATE PIVOTS
WILL BOLT TO THE 2 X 6 FACIA BOARD
IT IS A LITTLE HEAVY BUT WE HAD ALL THE
SCRAP AND PARTS TO DO IT THIS WAY
I WILL CUT SOME OUT OF IT TO REDUCE
THE SIZE AND WEIGHT LATER
HALF INCH SHEET PLYWOOD CUT TO
39 INCHES WIDE. AND TWO CEDAR 2 X 4s
LOTS OF HOLES, LIGHTER AND WILL LET WIND
BLOW THRU. ALSO REMOVED SOME FROM HINGE
MARKS SHOW WHERE WE NEED TO DRILL
WILL DO THIS IN THREE PLACES
AT 12 FEET , 24 FEET AND AT THE END
HAND IS SO I WON'T DRILL INTO THE TRAP
LIFTED IN PLACE
SECURED WITH HALF INCH BOLTS
FROM THE OUTSIDE
NOTE: STRIP ON BOTTOM LIP
TO STOP TIN FROM SLIDING OFF
ATTACHING TWO PIVOTING LEGS
MOMENT OF TRUTH
NOT BAD
AS YOU CAN SEE THERE IS NOT MUCH ROOM
BEFORE YOU GO DOWN THE BANKING
NOW IF WE CAN GET RID OF THIS SPRING
WIND, WE COULD GET BACK AT IT
All content of this page is the sole property of NINETYNINE.COM
And protectected under the standard copyright laws. 2011@NINETYNINE